Fabrication
The opening nook for the exhibit "A Seat at the Table". I made that napkin holder! It's a digital photo album made out of a raspberry pi!
Here is said napkin holder, after I painted and distressed it.
Other side
Inside, back of the LCD screen.
The table for the nook, which I also made.
These are the finished "racist lanterns' in the show "A Seat at the Table.
Tiny prototype light box plinth
Another prototype
Some plexi single-headphone holders and their prototypes
Initial concept for a screen
Prototype
......50 later.....
The screens!
Some table legs I coated in the happiest yellow.
The legs installed
The same table, but now focusing on the tree like thing..
I welded them.
There ended up being quite a few.. did I also mention that they were also monitor mounts AND had buttons on them? Oh, yes...
I welded these beams into this sea can to prep for the foam insulation, then presto! Wood storage!
After the foam
Some wood benches and screen I made, plus an artisanal fire pit...
Little cedar box I made
Scrolling ticker tape with colour changing RGBW LEDs that I made and programmed, using an Arduino Uno.
Prototype
the back
Vending machine that I reprogrammed and spruced up
I rewired and created this installation for the exhibit "All We Want is More: The Tobias Wong Project"
The collaboration corner in the exhibit, this I got to design!
